HP Model 715/100XC hp 9000 series 700 model 715 workstations service handbook - Page 130
Processor Board
View all HP Model 715/100XC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 130 highlights
Processor Board Before removing the processor board, perform the following steps: S Remove the optional external graphics processor (if installed). S Remove the floor stand. S Open the system unit. S Remove the EISA assembly or optional graphics (CRX or HCRX) board, if present. S Disconnect all internal and external cables. When installing the processor board, use a wide, flat object, such as a wooden ruler or flat-tipped screwdriver, between the front wall of the system unit and the edge of the processor board to lever the board toward the rear of the system (see Figure 5-45). This will enable you to align the screw hole and seat the connectors at the rear of the system unit. Swap the memory boards to the new/exchange processor board, as shown in the "Memory" section. If you are replacing a 715/C, 715/33, 715/50, or 715/75 processor board with another 715/C, 715/33, 715/50, or 715/75 processor board, remove the EEPROM from the failed processor board and install it in the new/exchange processor board, as shown in the "System EEPROM" section. Field Replaceable Units 5-45