HP Model 748 Model A4268A FWD SCSI Adapter InstallationandService Guide - Page 14
System Prerequisites, Hardware Prerequisites - 32
View all HP Model 748 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Preparing for the Installation 2. System Prerequisites Your system must meet some hardware and software prerequisites to support the FWD SCSI adapter. These prerequisites are described in the following sections. Hardware Prerequisites The required hardware is as follows: • GSC Expansion Adapter (A4262A or A4219A) or HCRX/VME Graphics Board (A4315A or A4316A) • A minimum of 32-MB RAM if running HP-UX version 10.20, or a minimum of 16-MB RAM if running HP-UX version 9.x, or a minimum of 24-MB RAM if running HP-RT Firmware Prerequisites The required firmware is as follows: • A Model 743 Single Board Computer (SBC) may require a firmware upgrade if the Boot ROM included in this kit is a later version than the one in use on your SBC. To determine if the Boot ROM of your SBC needs to be replaced, you need to determine the revision number, which can be done in one of two ways: use the Boot Console Handler (BCH) interface as described in the Model 743 Owner's Guide, or you can examine the label on the Boot ROM - a revision number is printed on the label. If the revision number on the Boot ROM installed on the Model 743 is a lower number than the one included in this kit, you should replace the Boot ROM with the one included in this kit. If the revision number on the Boot ROM installed on the Model 743 is equal to or greater than the one included in this kit, DO NOT replace the Boot ROM on the Model 743. • A Model 744 Single Board Computer does not require a firmware upgrade Software Prerequisites The required software is as follows: • For Model 743 SBC with HP-UX, software release 9.05 or later version. • For Model 744 SBC with HP-UX, software release 10.20 or later version. To identify which revision of HP-UX your workstation is running, enter the following command: 1-4