HP Neoware e90 HP TeemTalk Terminal Emulator 7.0 User Manual - Page 132

HP 700-92/96 Emulation The cursor will move to the leftmost column on the next line when the current line has been printed. You can cancel printing at the end of the current line by pressing Return. Note: If the cursor is positioned on a line below the last displayable line of data, nothing will be sent to the printer. Copy Line - F8 When a printer is connected and enabled by the To Ext Dev function, clicking this button or pressing F8 will cause a copy of the line containing the cursor to be sent to the printer. The cursor will move to the leftmost column on the next line when the line has been printed. Note: If the cursor is positioned on a line below the last displayable line of data, nothing will be sent to the printer. If the cursor is positioned on an empty line between two blocks of data, the printer will perform a carriage return and line feed. Device Modes This set of functions is asserted by pressing the F9 key (equivalent to the User System key) then F1 and F1 again. Device Control - F1 Clicking this button or pressing F1 will cause the Device Control functions to be asserted. These enable you to select the device(s) to which data is sent and also to copy portions of data from display memory to the printer. The buttons and keys F1 through F8 will function as described in the section "Device Control" on page 114. Record Mode - F2 This is used to copy data received from the host to the printer and/or display, depending on the setting of the To Ext Dev and To Display labels in the Device Control menu. 116 Function Keys & Buttons