HP NetServer LP 1000r Installing IBM OS/2 on an HP Netserver - Page 27
Device Support, Select Non-Listed IDE CD-ROM from the list, next deselect OTHER.
View all HP NetServer LP 1000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Device Support", Select "Non-Listed IDE CD-ROM" from the list, next deselect "OTHER". 6. Complete the OS/2 setup and Installation screen. Select the options that you want. Select Next to continue. 7. Click OK on the Advanced options screen to accept "Add existing programs to the desktop". 8. Complete the Networking Product configuration. You must configure networking products. There is no way to skip this section like in Warp Connect. However, there is a loopback Network driver available on the list which you can use if the NIC is not currently installed on the system or you can add your NIC driver at this time. (You may select no for file and print services but the system will still force you to install LAPS.) The Warp Server SMP4.0 will ask for more configuration information than the Warp 4.0. Please check your IBM installation manual for more details on those configuration questions. The following steps are provided for guidance only. For example Warp Server for SMP will ask for: First Name: Last Name: Department: Company: etc. 9. Complete configuration screen that shows a tree view of the tasks to complete. The arrows in red are must do items. 10. You must configure your adapter and the user ID. When done with the configuration panel click Install to begin the installation routine. Click OK to confirm. 11. The system will take about 25 minutes transferring files to your hard drive. You will see the screen "Updating system configuration" . When prompted select OK to install using default monitor type. Phase 4: Networking products Auto-Reboot two times 12. System will take about 5 minutes transferring files to the hard drive. Next an auto-reboot will occur. Remember to remove the NIC driver diskette from drive A: if one was used to avoid a boot error. 13. The system will reboot with the following message: Locked files device driver Processing locked files 27