HP NetServer LP 2000r HP Netserver Mass Storage Upgrade Guide - Page 15

Insert and Tighten Two Screws 1, and Then Insert and Tighten Six Screws 2

Get HP NetServer LP 2000r PDF manuals and user guides View all HP NetServer LP 2000r manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

Chapter 2 Installation 4. Using the two circular access holes in the chassis shown in Figure 2-3, insert and tighten two screws supplied with the upgrade kit. ◊ HP NetServer LH 3000 and LH 6000 access holes are on the side of the chassis. ◊ HP NetServer LH 3000r and LH 6000r access holes are on the top of the chassis. Figure 2-3. Insert and Tighten Two Screws (1), and Then Insert and Tighten Six Screws (2) 5. Insert six screws into the front of the hot-swap mass storage cage, as shown in Figure 2-3, and tighten them. 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
Chapter 2
Installation
11
4.
Using the two circular access holes in the chassis shown in Figure 2-3,
insert and tighten two screws supplied with the upgrade kit.
◊
HP NetServer LH 3000 and LH 6000 access holes are on the side of the
chassis.
◊
HP NetServer LH 3000r and LH 6000r access holes are on the top of
the chassis.
Figure 2-3. Insert and Tighten Two Screws (1),
and Then Insert and Tighten Six Screws (2)
5.
Insert six screws into the front of the hot-swap mass storage cage, as
shown in Figure 2-3, and tighten them.