HP NetServer LP 2000r HP Netserver Mass Storage Upgrade Guide - Page 24
Step 9, Replace Cover 1 and Front Bezel, Step 10, Install Hard Disk Drive Modules
View all HP NetServer LP 2000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Chapter 2 Installation Step 9: Replace Cover 1 and Front Bezel NOTE If you removed the air baffle indicated in Figure 2-4 or 2-5, replace it now, before you replace Cover 1. 1. Replace Cover 1 as described in your HP NetServer installation guide. 2. If the HP NetServer is mounted in a rack, slide the HP NetServer into the rack, and secure the HP NetServer to the rack, as described in the installation guide or rack documentation. 3. Install the front bezel as described in the installation guide or rack documentation. Lock the front bezel. 4. After the HP NetServer is secured in a rack with an anti-tip foot, you can retract the anti-tip foot if desired. Step 10: Install Hard Disk Drive Modules Hot-Swap Disk Drive Configurations NOTE If a duplex board is installed in the secondary mass storage cage, refer to the HP NetServer Duplex Kit Installation Guide or your HP NetServer installation guide for drive configurations and SCSI addresses (IDs). 20