HP NetServer LP 2000r HP Netserver Mass Storage Upgrade Guide - Page 31
HP NetServer, Ultra2 SCSI Hot-swap Hard Disk Drive and Tray User Guide
View all HP NetServer LP 2000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Chapter 2 Installation 4. If one or both LED indicators on a single module are not illuminated during the POST, the module may be installed incorrectly, or its light pipes (shown in Figure 2-15) may be damaged. Light Pipes Figure 2-15. LED Light Pipes on Ultra 2 Hard Disk Drive Module (Shown for Low-Profile Disk Module) Check the light pipe on the module as follows: a. Remove the disk drive module, as described in the HP NetServer Ultra2 SCSI Hot-swap Hard Disk Drive and Tray User Guide. b. Inspect the light pipes, shown in Figure 2-15, for damage. If a light pipe is damaged, contact your reseller. CAUTION The light pipes are fragile. Be careful not to damage them when you inspect them or when you reinsert the module. c. Reinstall the disk drive module, as described in the HP NetServer Ultra2 SCSI Hot-swap Hard Disk Drive and Tray User Guide. d. Restart the HP NetServer to determine whether the LED indicators become illuminated during the POST now. If not, contact your reseller. 27