HP Nx5000 HP Compaq nc6000 Notebook PC - Maintenance and Service Guide - Page 166
General Requirements, configuration of an EN 60 320/IEC 320 Standard Sheet C13
View all HP Nx5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 166 highlights
Power Cord Requirements General Requirements The requirements listed below are applicable to all countries: ■ The length of the power cord must be at least 1.5 meters (5.00 feet) and a maximum of 2.0 meters (6.50 feet). ■ All power cords must be approved by an acceptable accredited agency responsible for evaluation in the country where the power cord will be used. ■ The power cord must have a minimum current capacity of 10 amps and a nominal voltage rating of 125 or 250 volts AC, as required by each country's power system. ■ The appliance coupler must meet the mechanical configuration of an EN 60 320/IEC 320 Standard Sheet C13 connector for mating with the appliance inlet on the back of the notebook. B-2 Maintenance and Service Guide
B–2
Maintenance and Service Guide
Power Cord Requirements
General Requirements
The requirements listed below are applicable to all countries:
■
The length of the power cord must be at least 1.5 meters (5.00
feet) and a maximum of 2.0 meters (6.50 feet).
■
All power cords must be approved by an acceptable
accredited agency responsible for evaluation in the country
where the power cord will be used.
■
The power cord must have a minimum current capacity of 10
amps and a nominal voltage rating of 125 or 250 volts AC, as
required by each country’s power system.
■
The appliance coupler must meet the mechanical
configuration of an EN 60 320/IEC 320 Standard Sheet C13
connector for mating with the appliance inlet on the back of
the notebook.