HP OmniBook 7150 HP OmniBook - DiagTools User's Guide - Page 27

hardware detection phase, the hard disk drive will not be tested. For more

Get HP OmniBook 7150 - Notebook PC PDF manuals and user guides View all HP OmniBook 7150 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 27 highlights

Basic System Test What is Tested Each test listed above is performed only if it is appropriate for your PC configuration. For example, if your PC does not have a SCSI controller, no SCSI tests will be done. Furthermore, a component test will be performed only if the component was correctly detected in the hardware detection phase. For example, if you have recently installed an IDE hard disk drive and it was not detected during the hardware detection phase, the hard disk drive will not be tested. (For more information about hardware detection, refer to chapter 2.) Note DiagTools does not test components that have not been detected. However, we recommend that you continue with the basic system test to verify that the underlying components are functioning correctly. 3-7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
Basic System Test
3-7
Each test listed above is performed only if it is appropriate for your PC
configuration. For example, if your PC does not have a SCSI controller, no SCSI tests
will be done.
Furthermore, a component test will be performed only if the component was
correctly detected in the hardware detection phase. For example, if you have
recently installed an IDE hard disk drive and it was not detected during the
hardware detection phase, the hard disk drive will not be tested. (For more
information about hardware detection, refer to chapter 2.)
DiagTools does not test components that have not been detected. However, we
recommend that you continue with the basic system test to verify that the
underlying components are functioning correctly.