HP OmniBook 7150 HP OmniBook 7100 - User Guide Plug-In Module - Page 7

Using OmniBook Plug-In Modules -RWXEPPMRK ,SX7[ET 7YTTSVX 2SXI '%98-32 Installing Hot-Swap Support For the OmniBook 7150 only , the Agaté Tioman "hot-swap" software for Windows 95 and Windows 98 is loaded on the hard disk but it is not installed. If you install this software, you can switch most modules in the plug-in bay without shutting down the computer and rebooting. (This software does not support Windows NT.) • Click Start, Programs, Agaté Tioman for HP, Setup, then follow the onscreen instructions. Replacing a Plug-In Accessory Module • For Windows 95/Windows 98, if Agaté Tioman hot-swap software is installed, a plug-in module icon appears at the right end of the taskbar. This software lets you swap most plug-in modules without shutting down the computer. • If you are removing or inserting a hard disk drive in the module bay, you must shut down the computer. • If you are removing a battery and inserting another battery, you do not have to do steps 1 and 2 below-you can just change the batteries. -J ]SY EVI MRWIVXMRK SV VIQSZMRK E '(631 HVMZI (:( HVMZI SV ER] SXLIV X]TI SJ HVMZI ]SY QYWX YWI XLI LSXW[ET WSJX[EVI SV WLYX HS[R XLI GSQTYXIV‹SXLIV[MWI ]SY GSYPH PSWI HEXE 1. Close all files that are open from the plug-in module 2. If the plug-in module icon is present in the taskbar, right-click the icon, then click Remove Device. When prompted to remove the module, click OK. (You do not have to do this if the bay is empty or contains a battery.) -or- Click Start, Shut Down to shut down the computer. (You must do this if you are removing or inserting a hard disk drive in the module bay.) 3. Slide and hold the release latch, then pull out the module, as shown. 1-7