HP OmniBook 800 HP OmniBook 800 - 5/166 CD-ROM User Guide - Page 7

To connect the CD-ROM drive to your OmniBook

Get HP OmniBook 800 - Notebook PC PDF manuals and user guides View all HP OmniBook 800 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 7 highlights

CAUTION To connect the CD-ROM drive to your OmniBook Before you turn on the CD-ROM drive for the first time, remove the cardboard shipping insert from inside the CD compartment. 1. Make sure the CD-ROM drive has power-see "To use the power cable" or "To use batteries in your CD-ROM drive" earlier in this section. 2. Turn on the CD-ROM drive by pressing the POWER switch. A blinking "on" appears on the display of the CD-ROM drive. POWER Switch 3. Connect the 50-pin end of the SCSI adapter cable to the CD-ROM drive's SCSI connector. (If you're also connecting other SCSI devices, see "Connecting Several SCSI Devices" farther below.) 1-7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
1-7
To connect the CD-ROM drive to your OmniBook
CAUTION
Before you turn on the CD-ROM drive for the first time, remove the cardboard
shipping insert from inside the CD compartment.
1. Make sure the CD-ROM drive has power—see “To use the power cable” or “To
use batteries in your CD-ROM drive” earlier in this section.
2. Turn on the CD-ROM drive by pressing the POWER switch. A blinking “on”
appears on the display of the CD-ROM drive.
3. Connect the 50-pin end of the SCSI adapter cable to the CD-ROM drive’s SCSI
connector. (If you’re also connecting other SCSI devices, see “Connecting
Several SCSI Devices” farther below.)
POWER Switch