HP P3005 HP LaserJet P3005 - User Guide - Page 131
Tray size cannot be ANY SIZE/ANY, ACTION NOT CURRENTLY AVAILABLE
UPC - 882780566361
View all HP P3005 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 131 highlights
Control panel message 8X.YYYY EMBEDDED JETDIRECT ERROR To change press To skip, press STOP Access Denied MENUS LOCKED ACTION NOT CURRENTLY AVAILABLE ON TRAY X alternates with Tray size cannot be ANY SIZE/ANY CUSTOM Description Recommended action ● If the error appears while printing, determine whether it occurs when printing from a specific computer, a specific application, or a specific file. If all other computers, applications, or files can print without the error, then the problem may be only within one print job or computer. Make sure the computer has the most current printer drivers, or use a generic printer driver. ● If the error occurs when the device is first turned on, turn off the device, disconnect the LAN cable, and then turn on the device. This process will determine if errors occur from the network connection. If errors do not appear when the LAN cable is unplugged, it is possible traffic or signal on the network might be causing the error. Make sure to try all solutions suggested, especially upgrading the Jetdirect firmware. ● Disable the print server. ● For EIO print servers, remove the card. ● For embedded print servers, use the Service menu. ● If the problem persists, contact HP Support. The HP Jetdirect embedded print server has ● encountered a critical error. ● Turn the device off and then on. If the problem persists, contact HP Support. The device has an internal clock that tracks the date and time. You are prompted to set the correct date and time the first time you turn on the device. Press to change the date and time. Press Stop to skip this step. You can set the date and time later by using the SYSTEM SETUP menu. If the prompt appears each time you turn on the device, the clock is not working correctly. Contact HP support. The device administrator has enabled the control-panel security mechanism. You cannot modify control-panel settings in this circumstance. The message disappears after a few seconds, and the device returns to Ready or BUSY state. Contact the device administrator to change settings. You are trying to set duplex registration for a tray that is configured for ANY SIZE or ANY CUSTOM. Duplex registration is not available when the tray size is set to either of these settings. Change the size setting for the tray. ENWW Control-panel messages 119