HP P6000 HP P6300/P6500 Enterprise Virtual Array Installation Guide (5697-8091 - Page 44
Upgrading the iSCSI or iSCSI/FCoE module firmware, Set iSCSI Controller Time
View all HP P6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
NOTE: HP recommends using NTP settings if available on your IP network. This can provide redundancy with multiple time servers. Figure 37 Set iSCSI Controller Time Upgrading the iSCSI or iSCSI/FCoE module firmware NOTE: HP recommends that you always use the current versions of iSCSI and iSCSI/FCoE module firmware, which is available on HP Software Depot: http://www.hp.com/software.hp.com Updating the iSCSI or iSCSI/FCoE module firmware is separate from upgrading the XCS controller software, but the process is the same (using the Code Load function in HP P6000 Command View). NOTE: HP recommends that you update one module at a time to avoid a service interruption. To update the module firmware: 1. Select the iSCSI controller in the Navigation pane. 2. Select Code Load. The Code Load iSCSI Controller window opens (Figure 38 (page 44)). Figure 38 Code Load iSCSI Controller 3. Select Browse, and navigate to the new image file. 4. Select Next Step. 5. Select Finish. 6. Enter YES in the open dialog box. 7. Select Update. The iSCSI or iSCSI/FCoE module will reboot after it is upgraded. 44 Managing the iSCSI or iSCSI/FCoE module using HP P6000 Command View