HP P6110f Warranty - Page 23
Note to CATV System Installer, TV Antenna Connectors Protection
UPC - 884962155776
View all HP P6110f manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Laser Product Label The following label or equivalent is located on the surface of laser products: This label indicates that the product is classified as a CLASS 1 LASER PRODUCT. This label appears on a laser device installed in your product. Note to CATV System Installer This reminder is provided to call the CATV systems installer's attention to section 820-93 of the National Electric Code, which provides guidelines for proper grounding and in particular, specifies that the Coaxial cable shield shall be connected to grounding system of the building, as close to the point of cable entry as practical. TV Antenna Connectors Protection External Television Antenna Grounding If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is electrically grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper electrical grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna-discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. Lightning Protection For added protection of any product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug the product from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product from lightning and power line surges. 1 Antenna Grounding 7 6 5 4 3 2 Reference 1 2 3 4 5 6 7 Antenna Grounding Grounding Component Electric Service Equipment Power Service Grounding Electrode System (NEC Art 250, Part H) Ground Clamps Grounding Conductors (NEC Section 810-21) Antenna Discharge Unit (NEC Section 810-20) Ground Clamp Antenna Lead in Wire Power Lines An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. WARNING: When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them could be fatal. 21