HP P6500 HP EVA Updating Product Software Guide (xcs10001000) (5697-2423, Dece - Page 53
I/O tab of Disk Enclosure Properties window, Resetting the I/O module Step 18
View all HP P6500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Figure 26 I/O tab of Disk Enclosure Properties window NOTE: The Firmware revision fields are different for EVAx400 and P6000 disk enclosures. If the fields Assembly serial number, Hardware revision, and Hardware type on the I/O tab of the Disk Enclosure Properties window are blank, you can optionally reset the I/O modules to clear the blank fields after the I/O module firmware upgrade has completed successfully. Note that blank fields do not affect the array's ability to process host I/O. See "Resetting the I/O module" (page 54) for more information. e. Check the operational states that you recorded and proceed as follows: • Good: No action • Loading firmware: The I/O module firmware load is blocked. Corrective action is required somewhere on the array (but not on this I/O module). Continue with Step 18 • Any state other than Good or Loading firmware: Corrective action is required on this I/O module. Continue with Step 18. 18. Check the event log for the code-load-blocked code (066df308, critical event). If you do not see this event, contact your HP-authorized service representative for assistance. If you see this event, continue with Step 19. Step 5. Upgrading the controller software 53