HP Pavilion 11-e100 210 G1 Notebook PC Pavilion 11 Notebook PC Pavilion TouchS - Page 81
Before removing the system board, follow these steps, WLAN module see
View all HP Pavilion 11-e100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
Before removing the system board, follow these steps: 1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect the power from the computer by unplugging the power cord from the computer. 3. Disconnect all external devices from the computer. 4. Remove the battery (see Battery on page 40), and then remove the following components: a. Service door (see Service door on page 41) b. Hard drive (see Hard drive on page 42) c. Display assembly (see Display assembly on page 53) d. Bottom cover (see Bottom cover on page 61) e. Media card reader board (see Media card reader board on page 67) f. Fan (see Fan on page 68) NOTE: When replacing the system board, be sure that the following components are removed from the defective system board and installed on the replacement system board: ● WLAN module (see WLAN module on page 44) ● Memory module (see Memory module on page 46) ● Heat sink (see Heat sink on page 73) Remove the system board: 1. Disconnect the monitor connector board cable (1) from the system board. 2. Disconnect the speaker cable (2) from the system board. Component replacement procedures 71