HP Pavilion 7700 HP Pavilion PC's - (English) TEAC CD-W58E CD-Rewritable Drive - Page 3

Rear Panel Rear Panel S1 analog audio CSEL/Slave/Master connector configuration jumper interface connector power connector frame ground S1: Reserved for factory use only. analog audio output connector: You can use an audio cable to connect this connector to the audio input connector on a sound card. Pin assignments are described below: Pin Number 1 2 3 4 Audio Signal Left signal Ground Ground Right signal CSEL/Slave/Master configuration jumper: The CD-RW Drive includes three pairs of jumper pins on the rear panel that allow you to set the drive to CSEL, Slave, or Master mode. interface connector: Use an IDE interface ribbon cable to connect the CD-RW drive to an IDE interface in your computer. power connector: Connect the power connector to the +5VDC and +12VDC power sources. The +5VDC terminal is on the left as you face the rear panel; the +12VDC terminal is on the right. The two center terminals are ground terminals. FG: Frame ground. This is a ground connection for the CD-RW Drive. Configuring the CD-RW Drive The Master/Slave/CSEL jumper configuration of your TEAC CD-RW drive will depend on whether or not you have an IDE CD-ROM/DVD drive installed in your system. The following section will guide you through most typical system configurations. jumper set to CSEL jumper set to Slave jumper set to Master (default) TEAC CD-RW Installation Guide 3