HP Pavilion dm1-2100 HP Pavilion dm1 Notebook PC - Maintenance and Service Gui - Page 72
Security cable bracket
View all HP Pavilion dm1-2100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Remove the multi board: 1. Disconnect the multi board cable (1) from the system board. 2. Remove the 2 PM2.0×3.5 screws (2) that secure the multi board to the base enclosure. 3. To remove the multi board and cable (3), lift up the inside edge and slide the multi board out at a 45-degree angle. Reverse this procedure to install the multi board. Security cable bracket Description Security cable bracket (included in power connector spare part kit, part number 591851-001) Spare part number Before removing the security cable bracket, follow these steps: 1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect all external devices connected to the computer. 3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer. 4. Remove the battery (see Battery on page 36). 5. Remove the following components: a. hard drive cover (see WLAN module on page 38). b. Hard drive (see Drives on page 44). c. Keyboard (see Keyboard on page 47). d. Top cover (see Top cover on page 50). e. Display assembly (see Display assembly on page 58). 64 Chapter 4 Removal and replacement procedures