HP Portable 486 Compaq Portable 486c Personal Computer Maintenance and Service - Page 34
UART TX/RX buffer failure, Modem ROM; checksum
View all HP Portable 486 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
1201 - 08 UART TX/RX buffer failure 1201 - 09 INTERRUPT circuit failure 1201 - 10 COM1 set to invalid interrupt 1201 - 11 COM2 set to invalid interrupt 1201 - 12 DRIVER/RECEIVER control signal failure Error Recommended Code Description Action 1201 - 13 UART control signal The following steps apply interrupt failure to error codes 1201 - xx through 1210 - xx: 1201 - 14 DRIVER/RECEIVER 1. Refer to modem data failure documentation for Configuration utility 1201 - 15 Modem detection failure procedures. 2. Check the modem line. 1201 - 16 Modem ROM; checksum 3. Replace the modem and failure retest. 1201 - 17 Tone detection failure 1202 - xx Internal Modem Test 1202 - 01 Modem timed out waiting for SYNC (local loopback mode) 1202 - 02 Modem timed out waiting for response (local loopback mode) 1202 - 03 Modem exceeded data block retry limit (local loopback mode) 1202 - 11 Modem timed out waiting for SYNC (analog loopback originate mode) 1202 - 12 Modem timed out waiting for modem response (analog loopback originate mode) Error Recommended Code Description Action 1202 - 13 Modem exceeded data block The following steps apply retry limit (analog to error codes 1201 - xx loopback originate mode) through 1210 - xx: 1. Refer to modem