HP Portable 486 Compaq Portable 486c Personal Computer Maintenance and Service - Page 57
Tool and Software Requirements, Disassembly/Assembly Sequence Chart
View all HP Portable 486 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
o Conductive foam o Conductive table top workstations with ground cord of 1 megohm resistance o Static dissipating table or floor mats with hard tie to ground o Field service kits o Static awareness labels o Wrist straps and footwear straps providing 1 megohm ñ 10% resistance o Material handling packages - Conductive plastic bags - Conductive plastic tubes - Conductive tote boxes - Metal tote boxes - Opaque shielding bags - Transparent metallized shielding bag - Transparent shielding tubes Chapter 5.2 Tool and Software Requirements To service the COMPAQ PORTABLE 486c Personal Computer, you need the following: o Case utility tool o Flathead screwdriver o Modem terminating plug o Nonconductive probe o ROM removal tool o Torx screwdrivers, sizes T-10 and T-15 o 9 pin serial interface loopback plug o 25 pin parallel interface loopback plug Chapter 5.3 Disassembly/Assembly Sequence Chart Use the following chart as a reference along with the procedures in this chapter for removing and replacing the subassemblies of the COMPAQ PORTABLE 486c Personal Computer. 5.4 PREPARATION PROCEDURES | 5.5 |-- KEYBOARD | 5.6 |-- REAR PANEL || 5.7 | |-- OPTIONS COVER || 5.8 | |-- STANDARD BOARDS | | |-- Video Board | | |-- Processor Board | | |-- System ROM