HP ProLiant 1200 SMART-2DH Array Controller Reference Guide - Page 80
Handling Disk Drive Failures, DOS Partitions and, NetWare/intraNetWare Fault Tolerance
View all HP ProLiant 1200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
6-12 Installing the Operating System Drivers Handling Disk Drive Failures Although drive failures are not common, they may occur; it is important to protect your critical data. The best way to recover from a failed drive is to configure your drive system with some form of fault-tolerance. To ensure a quick and transparent recovery, Compaq recommends that you configure your SMART-2DH Controller with hardware fault tolerance. An advantage of hardware fault tolerance is that the controller is able to perform a background surface analysis on the hard drives to monitor for bad sectors and remap data to a new location on the media. This feature enhances the reliability and availability of your data. Compaq also recommends that you use good backup procedures, in case of catastrophic failure. If you discover a failed drive, perform the following steps: s Identify and document which physical drive has failed. Note the drive type and capacity. s Note which partition and volume, if any, has failed. This information is provided in the error message on the server console. It is also recorded in the server error log file which may be viewed using the SYSCON utility (intraNetWare 3.12) or NWADMIN utility (NetWare 4.x). s Make sure that you have a recent backup. If the drive is part of a faulttolerant mirrored volume, or a hardware fault-tolerant volume, you will be able to backup the data again in case of a second drive failure. s Locate a replacement drive of the same type and capacity. s Follow the instructions in the sections below for replacing a drive for your particular server configuration. DOS Partitions and NetWare/intraNetWare Fault Tolerance NetWare/intraNetWare does not mirror information on DOS partitions. Only hardware fault tolerance supports mirrored DOS partitions. If you have a mirrored drive containing a DOS partition, you need to restore the DOS partition information from another backup source. Writer: Pamela King Project: SMART-2DH Array Controller Reference Guide Comments: 295469-002 File Name: G-CH06.DOC Last Saved On: 2/27/98 12:01 PM COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED