HP ProLiant BL25p HP ProLiant BL25p Generation 2 Server Blade Maintenance and - Page 25

Access panel, Hard drive blank, Hard drive

Get HP ProLiant BL25p - G2 Server PDF manuals and user guides View all HP ProLiant BL25p manuals
Add to My Manuals
Save this manual to your list of manuals

Page 25 highlights

Access panel WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system components to cool before touching them. CAUTION: To prevent damage to electrical components, properly ground the server blade before beginning any installation procedure. Improper grounding can cause ESD. 1. Identify the proper server blade in the server blade enclosure. 2. Back up all server blade data. 3. Power down the server blade (on page 24). 4. Remove the server blade (on page 24). 5. Loosen the thumbscrew on the rear of the access panel. 6. Press down on the thumb indentations, slide the access panel toward the rear of the unit about 1.25 cm (0.5 in), and lift to remove the panel. To replace the component, reverse the removal procedure. Hard drive blank Remove the component as indicated. To replace the component, slide the component into the bay until it clicks. Hard drive To remove the component: 1. Determine the status of the hard drive from the hot-plug SAS hard drive LED combinations ("SAS and SATA hard drive LED combinations" on page 57). Removal and replacement procedures 25

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
Removal and replacement procedures
25
Access panel
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION:
To prevent damage to electrical components, properly ground the server blade
before beginning any installation procedure. Improper grounding can cause ESD.
1.
Identify the proper server blade in the server blade enclosure.
2.
Back up all server blade data.
3.
Power down the server blade (on page
24
).
4.
Remove the server blade (on page
24
).
5.
Loosen the thumbscrew on the rear of the access panel.
6.
Press down on the thumb indentations, slide the access panel toward the rear of the unit about 1.25
cm (0.5 in), and lift to remove the panel.
To replace the component, reverse the removal procedure.
Hard drive blank
Remove the component as indicated.
To replace the component, slide the component into the bay until it clicks.
Hard drive
To remove the component:
1.
Determine the status of the hard drive from the hot-plug SAS hard drive LED combinations ("
SAS and
SATA hard drive LED combinations
" on page
57
).