HP ProLiant DL185 HP Rack Rail Kit Installation Instructions (464164-001, Febr - Page 1
HP ProLiant DL185 - G5 Server Manual
View all HP ProLiant DL185 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
HP Rack Rail Kit installation instructions Overview This document contains instructions for installing HP rack rails into square and round hole racks for HP 1U and 2U servers. NOTE: For more information on preparing the server for installation, see the user guide that ships with the server. Kit contents • Two rack rails (left and right) • Mounting hardware for square and round hole racks • Two tie wraps NOTE: If mounting the server into threaded hole or telco racks, please see www.racksolutions.com to purchase mounting hardware. © Copyright 1999, 2008 Hewlett-Packard Development Company, L.P. First edition: February 2008 The information in this document is subject to change without notice. www.hp.com Important safety information See the Important Safety Information document included with the server. CAUTION: Electrostatic discharge (ESD) can damage electronic components. Be sure you are properly grounded (earthed) before beginning any installation procedure. Installation guidelines This installation is to be performed by qualified individuals who have knowledge of the procedures, precautions, and hazards associated with equipment containing hazardous electrical circuits. WARNING! These rails, when installed, form only a shelf for the server to rest on. The server is not attached to the rail by any other means. Use extreme caution when pulling the server out from the rack; it can slip and fall, causing damage to the server or injury. HP is not responsible for any damage or injury caused by the mishandling of the server. *464164-001* Page 1