HP ProLiant DL185 Dynamic Power Capping TCO and Best Practices White Paper (WW - Page 10

The following table summarizes the best practice for establishing Dynamic Power Caps for rack-mount servers. Table 5. Steps to Best Practices with Rack-Mount Servers Step Step 1 Step 2 Step 3 Step 4 Action Update server BIOS, iLO firmware, and Insight Control Environment software. Use HP Power Calculator to establish the initial Dynamic Power Cap for your rack-mount servers. Observe power usage using Insight Control Environment for a complete application duty cycle and re-adjust Dynamic Power Cap based on actual peak power usage. Continue to observe power usage and adjust if Dynamic Power Cap is invoked frequently. Setting Dynamic Power Cap with HP BladeSystem infrastructure When setting a Dynamic Power Cap for an HP BladeSystem enclosure, the process follow the same general principles as our rack-mount example with a few important differences. Please note that setting and adjusting Dynamic Power Caps should always be done in conjunction with your facilities department. Dynamic Power Capping within the BladeSystem enclosure works well when the servers support a variety of general purpose computing workloads because applications such as accounting, email, webservers, and database servers typically do not experience peak demands at exactly the same time. An enclosure devoted to high-performance computing such as financial modeling or scientific computing would not see as much power reclaimed. These scale-out applications typically have synchronized workloads that peak and idle concurrently. • First, download and apply the following updates to your HP ProLiant server (see Appendix for list of supported servers): Table 6. Component Requirement for BladeSytem Servers Required Component ROM BIOS iLO Onboard Administrator IPM component of Insight Control Environment Version Required 11/1/2008 or later 1.70 or later 2.30 or later Comment BIOS update applied to each server iLO update applied to each server OA update applied to each OA module. 2.0 or later IPM update applied to Insight Control Environment central management server. • Next, meet with your facilities person, to understand the available power budget for your HP BladeSystem infrastructure. This example assumes a 30 A 3-phase circuit with 8.6 kW of capacity. • Establish a goal for the number of enclosures that you wish to fit on the circuit and divide available circuit capacity by the number of enclosures. In our example, we will set a goal of two enclosures per circuit. We then divide the 8.6 KW circuits into two segments of 4300 W 10