HP R1500 HP UPS R7000 User Guide - Page 30
Connecting the ERM to the UPS, Charging the ERM batteries
![]() |
View all HP R1500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Connecting the ERM to the UPS Connect both ends of the split ERM cable to the ERM connectors on the UPS rear panel. To install additional ERMs, connect both ends of the split ERM cable from the next ERM into the connectors on the rear panel of the previous ERM. Up to four ERM units can be connected. Charging the ERM batteries Connect the UPS to a grounded utility power outlet. When the UPS is plugged in, it automatically enters Standby mode and begins charging the ERM batteries. With the UPS in Standby mode, allow the ERM batteries to charge for at least 24 hours before putting the UPS into service. IMPORTANT: To verify the attached ERMs are recognized, confirm the number of installed ERMs using the UPS front panel control via the UPS Status Menu. Installation and configuration 30
![](/manual_guide/products/hewlettpackard-rt3000-hp-ups-r7000-user-guide-68d2b43/30.png)