HP Scitex FB910 HP Scitex FB910 Printer Series - Release Notes - Page 3

Version 2.40 Release Notes Version 2.40 Release Notes • NEW Action message to replace UV lamp at 1000 hours - to avoid poor curing performance of the UV lamp bulbs, after a bulb reaches 1000 hours of service, an Action message appears on the control panel, and subsequent print jobs will not be printed until either the bulb is replaced or the lamp hours is reset to zero. Resetting the lamp hours is not recommended, but is allowed. The bulbs are covered by a factory warranty for 500 hours. • NEW Rail height reset at every printer restart - to ensure rail height accuracy, the rail is raised to its home position every time the printer is restarted. To reset the rail height, you can power off then power on the printer. • NEW Leading/trailing overprint setting - you can now specify an overprint value for the leading and trailing edges, and a different value for the right and left sides. (Menu > Printer Settings > Margins) • NEW Hewlett-Packard branding - this version of the software changes all MacDermid ColorSpan branding (splash screen, product names) to Hewlett-Packard Company branding. To avoid these changes, do not update to this or any future version of the printer software. • Measuring roll-fed media - to ensure accurate measurements by avoiding printed areas, the printer advances roll-fed media 4.0 inches (10 cm) prior to being measured. 0706408 Revision H 3