HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 117
AUTH-1031, Indicates that the authentication process failed to generate specific data that is
View all HP StorageWorks 1606 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
AUTH-1031 4 Recommended Action Usually this problem is transient. The authentication might fail. Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity ERROR AUTH-1031 Message , [AUTH-1031], ,, ERROR, , Failed to retrieve secret value: port . Probable Cause Indicates that the secret value was not set properly for the authenticated entity. Recommended Action Reset the secret value by using the secAuthSecret command. Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. Severity ERROR AUTH-1032 Message , [AUTH-1032], ,, ERROR, , Failed to generate for payload: length , error code , port . Probable Cause Indicates that the authentication process failed to generate specific data (that is, challenge, nonce, or response data) for an authentication payload. This usually relates to internal failure. A nonce is a single-use, usually random value used in authentication protocols to prevent replay attacks. Recommended Action Usually this problem is transient. The authentication might fail. Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity ERROR AUTH-1033 Message Probable Cause , [AUTH-1033], ,, ERROR, , Disable port due to unauthorized switch . Indicates that an entity was not configured in the switch connection control (SCC) policy and tried to connect to the port. Fabric OS Message Reference 47 53-1001338-01