HP StorageWorks 6000 HP StorageWorks VLS and D2D Solutions Guide (AG306-96028, - Page 79
Start Replication Wizard, Add Target Appliance
View all HP StorageWorks 6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
1. Start the replication wizard. a. Select the Replication tab in D2D GUI and then the Mapping Configuration tab. The wizard can then be initiated. All the configuration talks place on the source library. The only actions necessary on the target library are to configure it with an IP address. Note also that this is the starting point for the recovery wizard. Library 1 is the new source library in the D2D2500. Notice how the source library is initially "non-replicating" until it becomes part of a replication pair. b. Select Start Replication Wizard. 2. Add a target device to source device. a. Using the D2D replication wizard you can set the IP address of the target library device. You must know the target library IP address. In this case, 192.168.0.207. b. Input the target appliance IP address. c. Select Add Target Appliance. The target library appears to the source and is online. HP StorageWorks VLS and D2D Solutions Guide 79