HP StorageWorks 8/40 HP StorageWorks 8-Gb SAN Switch hardware reference manual - Page 40
Installing the outer rails HP 10000 series racks
View all HP StorageWorks 8/40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
4. Assemble the outer rails: a. Attach the left outer rail and the right outer rail to the rear mounting brackets, using two 1/4-20 hex nuts with captive star lock-washers attached loosely, as shown in Figure 13. Do not tighten the nuts. Figure 13 Installing the outer rails (HP 10000 series racks) b. Depending on the rack you are using, complete one of the following tasks: • For HP 10000 series racks, install two #10-32 x 1/2-inch Phillips pan-head screws with captive star lock-washers and two #10 adapter washers in the upper and lower hole locations of the right rail. Then install two #10-32 x 1/2-inch Phillips pan-head screws with captive star lock-washers and two #10 adapter washers in the upper and lower hole locations of the left rail. See Figure 14. Figure 14 Assembling the outer rails (HP 10000 series racks) 40 Installing and configuring an 8-Gb SAN Switch