HP StorageWorks Modular Smart Array 1000 HP StorageWorks Power Supply/Blower M - Page 1

Replacement Instructions hp StorageWorks Power Supply/Blower Modular Smart Array These instructions specifically pertain to the MSA1000 product family. The part may also be used in other HP products. Please refer to documentation for your specific product for detailed replacement instructions. If the product in which this part is being replaced is still under HP warranty, then the replacement part(s) referred to in these Replacement Instructions is provided under the terms and conditions of the Hewlett-Packard Company Limited Warranty for that product. A copy of this Limited Warranty may be viewed at: http://h18006.www1.hp.com/products/storageworks/warranty.html If this is a trade sale part (product out of warranty), then the replacement part(s) referred to in these Replacement Instructions is provided under HP's express limited warranty statement, which may be viewed at: http://customerops.corp.hp.com/1sw/pdm_om/warranty_support/policies/ 2330100.doc The replacement part takes on either the Limited Warranty Period of the part being replaced or a ninety-day period that begins upon installation of the replacement part, whichever is greater. The information contained on these replacement instructions is subject to change without notice. The only warranty for this replacement product is as noted above. Nothing in these replacement instructions should be construed as constituting an additional warranty. The information provided in these replacement instructions is provided "AS IS" and HP is not liable for technical or editorial errors or omissions contained herein. © Copyright 2004 Hewlett-Packard Development Company, L.P. Please note that this document is protected by federal copyright law and that no part of this document may be copied, reproduced or translated without the prior written consent of Hewlett-Packard Development Company, L.P. Printed in the USA. Power Supply/Blower Replacement Instructions First Edition (April 2004) Part Number: EK-CSRPS-AA. A01 E K- CS RP S - AA. A0 1 About this document This document describes the procedure for replacing the power supply/blower assembly used in the Modular Smart Array (MSA) products. Getting help If you need assistance replacing the power supply/blower, go to the HP support web site: http://www.hp.com/cgi-bin/hpsupport/index.pl Before you begin ■ Make sure you have a replacement part available before removing the failed component. Removing a power supply/blower impacts cooling within the enclosure. Caution: You have only 7 minutes to complete the replacement procedure or the enclosure may shut down due to overheating. Ensure that you reinstall a power supply within this time period. ■ If you would like to have a copy of the MSA User Guide available for reference, you can download it from the following web page: http://h18006.www1.hp.com/storage/arraysystems.html Caution: Parts can be damaged by electrostatic discharge. Use proper anti-static protection. Refer to the documentation that shipped with your system for additional information. Verifying power supply/blower failure The power supply and blower are separately replaceable components. Before replacing the power supply or blower, use the following methods to verify the component failure: ■ Check the power supply status LED (1, Figure 1). If the LED is off, it indicates a power supply or blower failure. Figure 1: Power supply/blower status LED 1 2 3 1 Status LEDs 0006b 2 Power supply/blower 1 3 Power supply/blower 2