HP StorageWorks Modular Smart Array 1000 HP StorageWorks 1000/1500 Modular Sma - Page 26

Creating LUNs A LUN is a logical storage unit comprised of one or more hard drives. When a LUN is initially created, the LUN Unit ID is automatically set to the same number assigned to the LUN. If desired, this LUN ID name can be changed. See "Assigning a name or ID to a LUN" on page 28 for procedural information. The basic command is add unit. A variety of options are available to modify the command. Basic command add unit[s] [spare="diskrange"] [stripe_size=s] [size=s] [max_boot=] [cache=] Command options #-the number to assign to the LUN. data="diskrange"-the number of an individual drive or range of drives to incorporate into the LUN. Disks are identified by box number and bay number. For example, disk110 identifies disk 10 in box number 1, and disk101-disk105 identifies disks 1 through 5 in box number 1. NOTE: Quotation marks must be entered both before and after the data disk drives that are to be included in the LUN. raid_level=r-the RAID fault-tolerance level to use, where r represents: 0 = RAID 0 (no fault tolerance) 1 = RAID 1 (mirroring) 5 = RAID 5 (distributed parity) 6 = Advanced Data Guarding (ADG) NOTE: If more than one pair of drives are included in a RAID 1 array, the data is striped across the first half of the drives in the array, and then each drive is mirrored to a drive in the remaining half of the drives for fault tolerance. This method is referred to as RAID 1+0. stripe_size=s-(optional) the stripe size to assign (in KB), where s represents 8, 16, 32, 64, 128, or 256 Kilobytes. RAID 0 uses stripe sizes 8, 16, 32, 64, 128, and 256 (Default: 128 KB) RAID 1 uses stripe sizes 8, 16, 32, 64, 128, and 256 (Default: 128 KB) RAID 5 uses stripe sizes 8, 16, 32, and 64 (Default: 16 KB) RAID 6 uses stripe sizes 8, 16, 32, and 64 (Default: 16 KB) size=syy-(optional) how much of the available space on the indicated drives is to be used for the LUN, where s represents the LUN size, and yy indicates MB or GB. (When GB is entered, all return displays will be converted to MB.) If no size is specified, the maximum available space of the included disks, up to 2 TB, will be assigned to the unit. spare="diskrange"-(optional) disk(s) to assign as a spare to the unit, where diskrange represents the disk number. More than one disk can be assigned as a spare to a LUN. And, the same drive can be assigned as an available spare to several different LUNs. maxboot=enable|disable-(optional) changes the size of the boot partition. Enable = (default) 8-GB boot partition Disable = 4-GB boot partition cache=enable|disable-(optional) determines whether to use the array controller cache for the LUN. Enable = (default) use the array controller cache Disable = do not use the array controller cache 26 Using the CLI