HP StorageWorks SN6000 HP StorageWorks 8/20q Fibre Channel Switch event messag - Page 36
Load and Activation NDCLA, The Non-Disruptive Code
View all HP StorageWorks SN6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Table 4 Alarm events and recommended action (Continued) Icon Event ID and message Description Action (A3007.0001-000C) (value voltage sensor shows valueV - ALARM CLEAR) (A3008.0000) (The configuration area was damaged or a Remake Filesystem was performed from PROM mode. You must perform a 'config restore' to clear this error.) (A4000.0001) (threshold of value hit rising trigger trigger_number in value second window on port port_number ALARM SET (A6000.0002) (Configured port speed for port port_number not compatible with media.) (A6001.0001) (cmon: insufficient memory) (A6001.0003) (cmon: switch failed NDCLA) The out-of-range voltage condition has cleared. None The configuration area was damaged or a Remake Filesystem was performed from Maintenance mode. Enter the config restore command to clear the error. If this does not correct the problem, contact your authorized maintenance provider. The switch exceeded the specified threshold for the rising trigger in the specified sample window. Investigate the specified port for problems, or adjust the rising trigger or sample window. The transceiver in the named port is not capable of transmitting at the configured port speed. Reconfigure the port speed or replace the transceiver. The hotreset command has failed due to insufficient memory on the switch. The switch has been returned to its state before the hotreset command was entered. If acceptable, enter the reset switch command to reboot the switch. Contact technical support if a non-disruptive code load and activation is required. The Non-Disruptive Code Load and Activation (NDCLA) has failed. The switch has performed a hard reset. None 36