HP Superdome SX2000 Site Preparation Guide, Fourth Edition - HP Integrity Supe - Page 17

WARNING, Table 1-15 HP Integrity Superdome/sx2000 Dual-Core CPU Configurations, Table 1-16

Page 17 highlights

cooling and electrical power. Table 1-15 also lists the recommended breaker sizes for 4-wire and 5-wire sources. WARNING! Do not connect a 380 to 415 V ac supply to a 4-wire PDCA. This is a safety hazard and results in damage to the product. Line-to-line or phase-to-phase voltage measured at 380 to 415 V ac must always be connected using a 5-wire PDCA. Table 1-15 HP Integrity Superdome/sx2000 Dual-Core CPU Configurations1 Cells (in cabinet) Memory (DIMMs I/O (fully per cell) populated) Typical Power Cooling (BTU/Hr) (Watts) Breaker Power (Watts)2 8 32 4 9490 32382 11957 8 16 2 7620 26001 9601 8 8 4 8140 27776 10256 8 8 2 7180 24500 9047 8 4 4 7620 26001 9601 8 4 2 6660 22726 8391 6 16 4 7320 24978 9223 6 16 2 6360 21702 8013 6 8 4 7000 23886 8820 6 8 2 6040 20610 7610 6 4 4 6680 22794 8417 6 4 2 5720 19518 7207 4 16 4 6170 21054 7774 4 16 2 5210 17778 6564 4 8 4 5960 20337 7509 4 8 2 5000 17061 6300 4 4 4 5760 19655 7257 4 4 2 4800 16379 6048 2 16 2 4010 13683 5052 2 8 2 3890 13274 4901 2 4 2 3780 12898 4763 1 Values in Table 1-15 are based on 25 W load I/O cards, 1 GB DIMMs and four Intel® Itanium ® dual-core processors with 18 MB or 24 MB cache per cell board or four PA-RISC processors with 64 MB. 2 These numbers are valid only for the specific configurations shown. Any upgrades can require a change to the breaker size. A 5-wire source uses a 4-pole breaker, and a 4-wire source uses a 3-pole breaker. The protective earth (PE) ground wire is not switched. Table 1-16 HP Integrity Superdome/sx2000 Single-Core CPU Configurations1 Cell (in cabinet) Memory (DIMMs I/O (fully per Cell) populated) 8 32 4 8 16 2 8 8 4 Typical Power (Watts) 9130 7260 7783 Cooling (BTU/Hr) 31181 24794 26580 Breaker Power (Watts)2 11503 9147 9806 Environmental Requirements 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35

cooling and electrical power.
Table 1-15
also lists the recommended breaker sizes for 4-wire and
5-wire sources.
WARNING!
Do not connect a 380 to 415 V ac supply to a 4-wire PDCA. This is a safety hazard
and results in damage to the product. Line-to-line or phase-to-phase voltage measured at 380 to
415 V ac must always be connected using a 5-wire PDCA.
Table 1-15 HP Integrity Superdome/sx2000 Dual-Core CPU Configurations
1
Breaker Power
(Watts)
2
Cooling (BTU/Hr)
Typical Power
(Watts)
I/O (fully
populated)
Memory (DIMMs
per cell)
Cells (in
cabinet)
11957
32382
9490
4
32
8
9601
26001
7620
2
16
8
10256
27776
8140
4
8
8
9047
24500
7180
2
8
8
9601
26001
7620
4
4
8
8391
22726
6660
2
4
8
9223
24978
7320
4
16
6
8013
21702
6360
2
16
6
8820
23886
7000
4
8
6
7610
20610
6040
2
8
6
8417
22794
6680
4
4
6
7207
19518
5720
2
4
6
7774
21054
6170
4
16
4
6564
17778
5210
2
16
4
7509
20337
5960
4
8
4
6300
17061
5000
2
8
4
7257
19655
5760
4
4
4
6048
16379
4800
2
4
4
5052
13683
4010
2
16
2
4901
13274
3890
2
8
2
4763
12898
3780
2
4
2
1
Values in
Table 1-15
are based on 25 W load I/O cards, 1 GB DIMMs and four Intel
®
Itanium
®
dual-core processors
with 18 MB or 24 MB cache per cell board or four PA-RISC processors with 64 MB.
2
These numbers are valid only for the specific configurations shown. Any upgrades can require a change to the
breaker size. A 5-wire source uses a 4-pole breaker, and a 4-wire source uses a 3-pole breaker.
The protective earth
(PE) ground wire is not switched.
Table 1-16
HP Integrity Superdome/sx2000 Single-Core CPU Configurations
1
Breaker Power
(Watts)
2
Cooling (BTU/Hr)
Typical Power
(Watts)
I/O (fully
populated)
Memory (DIMMs
per Cell)
Cell (in cabinet)
11503
31181
9130
4
32
8
9147
24794
7260
2
16
8
9806
26580
7783
4
8
8
Environmental Requirements
17