HP Surestore 660ex HP SureStore Optical Disk Jukeboxes User's Guide - C1104-90 - Page 21

Connecting a 4- or 6-Drive Jukebox

Get HP Surestore 660ex - Optical Jukebox PDF manuals and user guides View all HP Surestore 660ex manuals
Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

Chapter 1: Setting upStheettiDngiskUpDrthivee Jukebox CAUTION NOTE Setting Up the Jukebox Connecting a 4- or 6-Drive Jukebox Connecting a 4- or 6-Drive Jukebox Make sure that all peripheral devices connected to the host computer have been properly shut down. If the host computer is connected to a network, check with the system administrator before switching off power. Removing the Customer Access Panel 1. Switch off power to the host computer before you connect the jukebox The jukebox ships from the factory with two screws securing the bottom of the customer access panel to the side of the jukebox. These screws are removed during the process of unpacking and removing the jukebox from the shipping pallet. These screws may not have been replaced. It is a good idea to use the screws to secure the access panel to the jukebox since they must be in place if the jukebox is ever reshipped. If you have to replace these screws, they are 6/32 x .437. 2. Remove the customer access panel by pulling on the bottom of the panel and then lifting it off (see Figure 1-1). (If screws are installed, use a flatblade screwdriver or T-15 Torx driver.) Chapter 1 1- 9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
Chapter 1
1-9
Setting Up the Jukebox
Connecting a 4- or 6-Drive Jukebox
Chapter 1: Setting
up the Disk Drive
Setting Up the
Jukebox
Connecting a 4- or 6-Drive Jukebox
CAUTION
Make sure that all peripheral devices connected to the host computer have been
properly shut down.
If the host computer is connected to a network, check with the
system administrator before switching off power.
Removing the Customer Access Panel
1.
Switch off power to the host computer before you connect the jukebox
NOTE
The jukebox ships from the factory with two screws securing the bottom of the
customer access panel to the side of the jukebox.
These screws are removed during
the process of unpacking and removing the jukebox from the shipping pallet.
These screws may not have been replaced.
It is a good idea to use the screws to secure the access panel to the jukebox since
they must be in place if the jukebox is ever reshipped.
If you have to replace these screws, they are 6/32 x .437.
2.
Remove the customer access panel by pulling on the bottom of the panel and
then lifting it off (see Figure 1-1). (If screws are installed, use a flatblade
screwdriver or T-15 Torx driver.)