HP Tc2120 Microsoft Windows Server 2003 .NET - Install Procedures v1.51_re
HP Tc2120 - Server - 256 MB RAM Manual
UPC - 808736945332
View all HP Tc2120 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP Tc2120 manual content summary:
- HP Tc2120 | Microsoft Windows Server 2003 .NET - Install Procedures v1.51_re - Page 1
?? Perform Windows Server 2003 Server Installation. ?? Completing the Installation (HP drivers, Recovery Console). ?? Configure the System. ?? Configure the Network. ?? Additional HP accessories. Prepare the Installation Please refer to the Chapter 1 "Preparing your HP Server tc2120 for your NOS - HP Tc2120 | Microsoft Windows Server 2003 .NET - Install Procedures v1.51_re - Page 2
configuration. Section 1. Create the Drivers Diskettes 1. Insert a blank, formatted 3.5" diskette into a the floppy drive of a PC running Microsoft Windows. 2. Insert your HP Startup CD into the PC's CD-ROM drive and follow the onscreen instructions to create the appropriate Windows Server 2003 - HP Tc2120 | Microsoft Windows Server 2003 .NET - Install Procedures v1.51_re - Page 3
to specify additional adapters. b. When prompted, insert the SCSI RAID driver diskette you created from the tc2120 startup CD. c. Press Enter to continue. d. Select the Adaptec to use the entire drive to install Windows Server 2003 then press Enter. Otherwise, press C to create a partition. In - HP Tc2120 | Microsoft Windows Server 2003 .NET - Install Procedures v1.51_re - Page 4
sure to remove any driver diskette before the system reboots. 14. You can now proceed through the customization of your installation using the graphical interface. NOTE The network settings may need to be customized to your environment. Please refer to Microsoft Server 2003 manuals should you need - HP Tc2120 | Microsoft Windows Server 2003 .NET - Install Procedures v1.51_re - Page 5
OS may not install the most current HP supported drivers. The following procedure will help you to install/update the driver(s) using the HP Startup CD. An Example of installing the Promise FastTrak100 TX2 IDE RAID driver 1. Insert the HP tc2120 Startup CD in your new server. If CD-ROM auto-start is - HP Tc2120 | Microsoft Windows Server 2003 .NET - Install Procedures v1.51_re - Page 6
2003 follow the on-screen instructions to create the Windows Server 2003 embedded NIC drivers diskette. 3. After creating the drivers diskette, remove the HP tc2120 Startup CD. 4. Open Start | Control Panel | System | Hardware | Device Manager. 5. Open the "Network Adapters" tree and double click - HP Tc2120 | Microsoft Windows Server 2003 .NET - Install Procedures v1.51_re - Page 7
in the log. Click on Start | All Programs | Administrative tools | Event viewer. NOTE Windows Server 2003 Event Viewer may have recorded network errors because your network is not configured yet. Please disregard these errors. 6. Exit event viewer. PHASE 2 - Initialize Hard Disk Drive NOTE - HP Tc2120 | Microsoft Windows Server 2003 .NET - Install Procedures v1.51_re - Page 8
to start functioning. It is important that you configure the proper IP address to be able to communicate with the clients: 1. Click Start | Control Panel | Network Connections | Local Area Connection on your HP server. NOTE If your HP server hosts several Network adapters, the window will show one - HP Tc2120 | Microsoft Windows Server 2003 .NET - Install Procedures v1.51_re - Page 9
steps to take before proceeding with Server configuration. 4. Click Next to continue. 5. From the "Server Role" menu select "Domain Controller instructions correspond to the standard steps for new domain creation. You may customize the options proposed by Windows Server 2003 to match your networked - HP Tc2120 | Microsoft Windows Server 2003 .NET - Install Procedures v1.51_re - Page 10
If the current network does not contain a DNS server, choose "No, just install and configure DNS on configuring the active directory and DNS services, if chosen. It will take a few minutes to complete. 20. If prompted, insert the Windows Server 2003 CD-ROM and click OK to continue. 21. Configuring - HP Tc2120 | Microsoft Windows Server 2003 .NET - Install Procedures v1.51_re - Page 11
8 Installing Microsoft Windows Server 2003 Section 6. Additional HP Accessories The hp server tc2120 supports the following HP accessories: ?? NC3123 Fast Ethernet NIC PCI 10/100 ?? NC7131 Gigabit server Adapter PCI 1000 ?? HP Adaptec 29160 SCSI Controller ?? HP Adaptec 29160i SCSI Controller - HP Tc2120 | Microsoft Windows Server 2003 .NET - Install Procedures v1.51_re - Page 12
and services for troubleshooting purposes. HP therefore recommends that you install the Recovery Console (see option 3 below) to enhance the system configuration. Recovery option #1: Last known good configuration ?? Activated by pressing F8 during the system startup process of Windows Server 2003 - HP Tc2120 | Microsoft Windows Server 2003 .NET - Install Procedures v1.51_re - Page 13
when done troubleshooting. Installing RC 1. Insert the Windows Server 2003 CD-ROM . If CD-ROM auto-start is enabled, click exit to close the applet. 2. Open a command prompt, and type D:\I386\WINNT32 /CMDCONS (Where D: is the CD-ROM drive letter) 3. Follow the screen instructions - HP Tc2120 | Microsoft Windows Server 2003 .NET - Install Procedures v1.51_re - Page 14
Windows Server objective. 7. Type exit when done troubleshooting. NOTE The file access security can of the necessary system state data, system services and disks associated with the operating system . ASR Restore mode : 1. Boot from the Windows Server 2003 CD-ROM. 2. When prompted during the text - HP Tc2120 | Microsoft Windows Server 2003 .NET - Install Procedures v1.51_re - Page 15
the installation process. On-Line Information and Software Sources ?? HP World Wide Web access: http://www.hp.com/ ?? Microsoft World Wide Web access: http://www.microsoft.com/ ?? Microsoft Product Support Services: http://support.microsoft.com/directory ?? Windows NT Automated Database: Advanced
1
8
Installing Microsoft Windows Server
2003
This chapter is a supplement to the
HP Server tc2120 Network Operating System
Installation Guide
(HP part number 312977-001) that came with your server and
provides instructions for installing Microsoft Windows Server 2003 (formerly
known as "Windows .NET").
High Level Process Flow
??
Perform Windows Server 2003 Server Installation.
??
Completing the Installation (HP drivers, Recovery Console).
??
Configure the System.
??
Configure the Network.
??
Additional HP accessories.
Prepare the Installation
Please refer to the Chapter 1 "Preparing your HP Server tc2120 for your NOS
installation" for our recommendations on server preparation.
Then gather the following material:
??
HP Server tc2120 Startup CD
??
Microsoft Windows Server 2003 CD-ROM.
??
Up to three blank, formatted 3.5-inch diskettes
??
Two or more clients for testing purpose (Optional)
NOTE
Disable SCSI Support Before Using ATA RAID Controller if
present.
Due to system
resource limitations
,
the Promise
FastTrak100 TX2 IDE RAID controller is not compatible with
systems having SCSI capabilities.
(The ATA and SCSI
functionality cannot operate simultaneously).
You must
disable SCSI support in Setup before you can use the RAID
controller.
To disable SCSI support, follow these steps:
1.
Remove any installed SCSI HBA cards from the PCI slots.