HP Tc2120 Microsoft Windows Server 2003 .NET - Install Procedures v1.51_re - Page 2

Chapter 8 Installing Microsoft Windows Server 2003 2. Install the ATA RAID controller into PCI slot 1 and connect the IDE drives. 3. Turn on the system. 4. Press F10 to enter Setup. 5. Select Boot from the menu. 6. Select Boot Device Priority. 7. Select SCSI Hard Drive and press Enter. 8. Select Promise Fast Track Raid Controller \ HDD 0 and press Enter. 9. Press F6 to Save and Exit. Your system is now ready to use the ATA RAID controller, but SCSI devices will not be functional. 10. On boot, press Crtl-F to enter the IDE RAID Configuration Utility and configure the IDE array as usual. Please refer to the Fast Track 100 Reference guide off of http://www.promise.com/ for additional information on array configuration. Section 1. Create the Drivers Diskettes 1. Insert a blank, formatted 3.5" diskette into a the floppy drive of a PC running Microsoft Windows. 2. Insert your HP Startup CD into the PC's CD-ROM drive and follow the onscreen instructions to create the appropriate Windows Server 2003 drivers diskette. NOTE If the Windows PC does not auto-start the Startup menu, start it by opening Startup.htm found at the root level of the Startup CD. Section 2. Perform Windows Server 2003 Installation 1. Boot your new server from the Windows Server 2003 CD-ROM. 2. You will see a message that reads, "Setup is inspecting your hardware configuration". The setup screen will be displayed. 3. The system will briefly show at the bottom of the display "Press F6 if you need to install a third party SCSI or RAID controller". 2