HP Vectra 486N and NI D27xxA essai - Page 6

Configuring the SCSI Bus Configure/View It is recommended that you do not change these settings. Interface Settings Menu SCSISelect(TM) Utility v1.xxx Configuration SCSI Bus Interface Definitions Host Adapter SCSI ID 7 SCSI Parity Checking Enabled Host Adapter SCSI Termination Automatic Additional Options Boot Device Options Press SCSI Device Configuration Press Advanced Configuration Options Press - Reset to Host Adapter Defaults BIOS Information Interrupt (IRQ) Channel 15 I/O Port Address F800h SCSI Channel Interface Definitions: • Host Adapter SCSI ID Changes the adapter SCSI ID from its default value of 7. • SCSI Parity Checking Enable or disable host adapter SCSI parity checking. Most currently available SCSI devices do support SCSI parity. You should disable SCSI Parity Checking if any of the attached SCSI devices do not support SCSI parity. • Host Adapter SCSI Termination It is recommended that you leave this field on its default setting of Automatic. This way, if the host adapter detects a SCSI device connected to either its internal or external connectors, then it enables its terminators (the adapter is at the end of the SCSI bus). If the host adapter detects devices connected to both its internal and external connectors, then it disables its terminators. 2 English