HP Vectra 486N and NI D27xxA essai - Page 7

Configuring the SCSI Bus Additional Options: • Boot Device Options Press to display the Boot Device Configuration menu, described on the next page. • SCSI Device Configuration Press to display the SCSI Device Configuration menu. • Array 1000 BIOS (only if HP FastRAID is installed) This option is enabled by default, and instructs the system to use the special BIOS for the FastRAID option. • Advanced Configuration Options Press to view the Advanced Configuration Options menu. Boot Device Configuration Menu This menu lets you configure the SCSI boot device. To find out the SCSI ID of a specific SCSI device, you can run the SCSI Disk Utilities (refer to page 7). BooBtooDtevDiecveicCeonCfoingfuirgautriaotnion Select SCSI peripheral from which to boot To view peripheral by ID# select "SCSI Disk Utilities" from previous menu Boot SCSI ID 0 Option Listed Below Has NO EFFECT if MULTI LUN Support is Disabled Boot LUN Number 0 Use the and keys to move between options. Press to display a menu with a selection of values. • Boot SCSI ID This parameter is the SCSI ID of the boot device. The default value is 0. • Boot Lun Number More advanced SCSI devices can have several logical units. This option indicates the logical unit (or Lun) on which to boot for the drive chosen in the Boot SCSI ID. The default value is 0. Use the HP Setup program to select the boot device. You enter Setup by pressing F2 during startup. English 3