HP Vectra VL800 hp vectra vl800, technical reference manual - desktop and mini - Page 86
INTEL NIC (Network Interconnect) LAN Card, INTEL NIC LAN Card Features
View all HP Vectra VL800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
4 Interface Cards Network Cards INTEL NIC (Network Interconnect) LAN Card INTEL NIC LAN Card Features Feature Description Interface LED Labels IEEE802.3 100 Base-TX IEEE802.3 10 Base-T 32-bit 10/100 BT full duplex RJ LAN Port Two LEDs: • one for act/lnk (activity and link) • one for 10 MB operation (on = 100 MB, off = 10MB). PCI 2.2 Specification, PC 99. Power Management • Wfm 2.0 compliant • RPO and RWU for APM Windows 95 and Windows 98 • OnNow 1.0, APM 1.2 • PCI power management 1.1 • VccAux s3.3 V support via PCI bus 2.2 • VccAux 5 V support via 3-pin WOL. Manageability DMI 2.0 and DMI 2.0 SNMP mapper Diagnostic • Windows and DOS based • Mac address DOS report tool • User Diag for DOS, Windows NT 4, Windows 95 and Windows 98. Drivers Major OSes, Minor OSes Boot ROM Onboard flash ROM Remote Wake Up (RWU) This feature enables a host computer to remotely (over the network) power on computers and wake computers up from energy-saving Sleep mode. For these features to work, use the Setup program to configure the BIOS. INTEL NIC LAN Card LED Descriptions LED ACT/LNK On Adapter and hub are receiving power. Cable connection is good. Flashing Receiving or sending packets 100 TX Operating at 100 Mbps N/A Off Adapter and hub are not receiving power. Cable connection could be faulty or there is a driver configuration problem. Operating at 10 Mbps 86