HP Visualize J7000 hp Visualize J5000, J7000 workstations parts removal and re - Page 36
Replacing the DDS-3 Tape Drive
![]() |
View all HP Visualize J7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Parts Removal and Replacement Removing and Replacing the DDS-3 Tape Drive 3. Gently slide the DDS-3 drive tray assembly out of the chassis and disconnect the power and ribbon cables from the DDS-3 tape drive. 4. Remove the DDS-3 drive tray assembly from the drive bay. Replacing the DDS-3 Tape Drive Figure 2-32. Replacing the DDS-3 Tape Drive DDS-3 tape drive Figure 2-33. Securing the DDS-3 Tape Drive TST-c1-r15e5wTTsoorxrxscrew T-T1-515TToorxrxSsccrreewws 1. Reconnect the power and ribbon cables and gently slide the DDS-3 drive carrier halfway into the tape drive bay. 2. From the front of the workstation, push the DDS-3 drive carrier assembly into the drive bay so that the assembly rests flush against the front panel. Take care not to pinch the drive ribbon cable; reach in through the top of the workstation, where the EMI cover was, to make any required adjustments. 36 Chapter 2
![](/manual_guide/products/hewlettpackard-visualize-j5000-hp-visualize-j5000-j7000-workstations-parts-removal-replacement-guide-a497890051-1a5e502/36.png)