HP Workstation c3650 hp workstation hp-ux - Visualize fx graphics card install - Page 12

Table 1-2 Introduction Prerequisites revision date that is listed in the output may be later than the one shown above. For example, if the ACE revision date listed for HP-UX 10.20 is later than December 1999, then the proper ACE software bundle is installed on your workstation for Visualize fx products. If you are not running HP-UX, revision 10.20 or 11.0 with these ACE bundles or a later release, you need to update your software before installing your graphics card. Contact your designated service representative for information on receiving an update. The ACE software bundles and Quality Packs are also available for downloading from the http://software.hp.com website. The bundles will require approximately 133 Mb of disk space. 3. You must have an HP-supported monitor running at 75Hz with a 1280X1024 resolution, or a full multimode color monitor. For fxe, fx5 and fx10 graphics cards, monitors with Enhanced Video Connector (EVC), D-Sub connectors or 5 BNC connectors (RGB, vertical sync, horizontal sync) will work.The HP Visualize fx family graphics card will not function with older HP monitor types that use a sync on green signal. This includes monitors such as the HP 1097A/B/ C/D, A2088A, and A2828A/B which only have 3 RGB connectors. The fxe graphics card supports the following monitor resolutions: Visualize fxe Supported Resolutions Width x Height Frequency Font 1280x1024 1024x768 1600x1200 75Hz 75Hz 75Hz 10x20 8x16 10x20 1600x1024 76Hz 10x20 Description VESA VESA VESA 12 Chapter 1