HP Xw460c HP BladeSystem c-Class Site Planning Guide - Page 53
Rack-free environment requirements
View all HP Xw460c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
• Front door: The clearance from face of rack to inside of the front door must be a minimum of 77 mm (3 in). • Rear door: The clearance between the rear of the enclosure and the rear rack door must be a minimum of 175 mm (6.9 in) to accommodate system cabling. • Side: The clearance between the installed rack component and the side panels of the rack must be a minimum of 70 mm (2.75 in). • Width: 483 mm (19 in) • Depth: Maximum clearance between front and rear RETMA rails is 864 mm (34 in). Minimum clearance for round-hole racks is 627 mm (24.7 in). Minimum clearance for square-hole racks is 635 mm (25 in). • The rack must be able to accept the adjustable rack rails that are shipped with each enclosure: o Minimum rail length: 635 mm (25 in) o Maximum rail length: 864 mm (34 in) Rack-free environment requirements The HP BladeSystem c7000 Enclosure (referred to as the enclosure) can be used in a rack-free environment. The following conditions must be met when performing a rack-free installation: • A fully-populated enclosure can weigh up to 217.7 kg (480 lb). The object supporting the enclosure must be able to withstand this weight. • The enclosure should be supported by a sturdy, flat surface. WARNING: To reduce the risk of personal injury or damage to the equipment in a rack-free environment: • Never stack an enclosure on top of another enclosure. • Never place equipment on top of an enclosure. • Never place an enclosure on a surface that cannot support up to 217.7 kg (480 lb). Hardware specifications and requirements 53