HP Xw6600 HP xw Workstation series - CRU Dataport DX115 kit installation - Page 4

Step 1-Preparing the workstation To prepare the workstation: 1. Refer to your workstation documentation for instructions on disassembling and preparing the workstation for installation. Follow the instructions for shutting down power and disconnecting all power from the system. 2. Remove the access panel and front bezel of your workstation. If necessary, refer to the Service and Technical Reference Guide for your HP Workstation at http://www.hp.com/support/ workstation_manuals. Step 2-Installing the DX115 case into the optical drive bay Refer to the steps for your workstation in the following sections. CAUTION: Insert or remove the carrier (with a disk drive) only when the workstation is shut down. Other procedures may result in system hangs, data loss or even drive damage. (The component supplier's user guide describes a procedure for inserting or removing the carrier (with drive) while the workstation is booted and then powering the drive via the enclosure's power switch. Microsoft Windows XP and Vista do not support this action.) HP xw6000 Workstation series 1. Remove and discard the counter-sunk screw at the side of the DX115 case as shown (for xw6000 series only). This hole will be used for the shipping screw. 2. Install the DX115 unit in the optical drive bay using the quick release system. 4 CRU Dataport DX115 kit installation ENWW