HP Xw6600 HP xw Workstation series - CRU Dataport DX115 kit installation - Page 7

CAUTION, Connect the power 1 and data 2 cables to the primary upper ports on the unit.

Get HP Xw6600 - Workstation - 2 GB RAM PDF manuals and user guides
UPC - 883585731121
View all HP Xw6600 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 7 highlights

Step 4-Completing the workstation assembly CAUTION: Insert or remove the carrier (with a disk drive) only when the workstation is shut down. Other procedures may result in system hangs, data loss or even drive damage. (The component supplier's user guide describes a procedure for inserting or removing the carrier (with drive) while the workstation is booted and then powering the drive via the enclosure's power switch. Microsoft Windows XP and Vista do not support this action.) 1. After the drive is installed in the carrier. Insert the drive carrier in the case. Press the handle in (1) and use the key (2) to lock the carrier if shipping the unit (3). 2. Connect the power (1) and data (2) cables to the primary (upper) ports on the unit. 3. To prepare your installed hard drive for operation, refer to the appropriate hard drive documentation. 4. If shipping the unit, use the key to lock the carrier and install the shipping screw as described in the previous steps. ENWW Step 4-Completing the workstation assembly 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
Step 4—Completing the workstation assembly
CAUTION:
Insert or remove the carrier (with a disk drive) only when the workstation is shut down.
Other procedures may result in system hangs, data loss or even drive damage. (The component
supplier’s user guide describes a procedure for inserting or removing the carrier (with drive) while the
workstation is booted and then powering the drive via the enclosure’s power switch. Microsoft Windows
XP and Vista do not support this action.)
1.
After the drive is installed in the carrier. Insert the drive carrier in the case. Press the handle in (1)
and use the key (2) to lock the carrier if shipping the unit (3).
2.
Connect the power (1) and data (2) cables to the primary (upper) ports on the unit.
3.
To prepare your installed hard drive for operation, refer to the appropriate hard drive
documentation.
4.
If shipping the unit, use the key to lock the carrier and install the shipping screw as described in
the previous steps.
ENWW
Step 4—Completing the workstation assembly
7