HP Z24i User Guide - Page 18

Removing the monitor stand, Mounting the display head

Get HP Z24i PDF manuals and user guides View all HP Z24i manuals
Add to My Manuals
Save this manual to your list of manuals

Page 18 highlights

Removing the monitor stand You can remove the display head from the stand to install the display head on a wall, a swing arm, or other mounting fixture. IMPORTANT: Before beginning to disassemble the monitor, be sure the monitor is turned off and all cables are disconnected. 1. Disconnect and remove all cables from the monitor. 2. Position the monitor facedown on a flat surface covered by a soft clean cloth. 3. Press the release button on the rear of the display head (1), and then lift the bottom of the stand up (2) and slide the stand back (3) to remove it. Mounting the display head The display head can be attached to a wall, swing arm, or other mounting fixture. NOTE: This apparatus is intended to be supported by a UL or CSA Listed wall-mount bracket. IMPORTANT: This VESA mount kit supports the VESA industry-standard 100 mm mounting holes. To attach a third-party mounting solution to the VESA mount, use four 4 mm, 0.7 pitch, 10 mm-long screws. Longer screws must not be used because they may damage the monitor. It is important to verify that the manufacturer's mounting solution is compliant with the VESA standard and is rated to support the weight of the monitor display panel. For best performance, it is important to use the power and video cables provided with the monitor. 1. Remove the monitor stand if it is attached to the display head. Refer to Removing the monitor stand on page 12. 12 Chapter 1 Getting started

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
Removing the monitor stand
You can remove the display head from the stand to install the display head on a wall, a swing arm, or other
mounting fixture.
IMPORTANT:
Before beginning to disassemble the monitor, be sure the monitor is turned off and all cables
are disconnected.
1.
Disconnect and remove all cables from the monitor.
2.
Position the monitor facedown on a flat surface covered by a soft clean cloth.
3.
Press the release button on the rear of the display head (1), and then lift the bottom of the stand up (2)
and slide the stand back (3) to remove it.
Mounting the display head
The display head can be attached to a wall, swing arm, or other mounting fixture.
NOTE:
This apparatus is intended to be supported by a UL or CSA Listed wall-mount bracket.
IMPORTANT:
This VESA mount kit supports the VESA industry-standard 100 mm mounting holes. To attach
a third-party mounting solution to the VESA mount, use four 4 mm, 0.7 pitch, 10 mm–long screws. Longer
screws must not be used because they may damage the monitor. It is important to verify that the
manufacturer’s mounting solution is compliant with the VESA standard and is rated to support the weight of
the monitor display panel. For best performance, it is important to use the power and video cables provided
with the monitor.
1.
Remove the monitor stand if it is attached to the display head. Refer to
Removing the monitor stand
on page
12
.
12
Chapter 1
Getting started