HP Z32 User Guide - Page 12
Input Control, and then the desired DisplayPort setting.
View all HP Z32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
● Connect one end of a Mini DisplayPort cable to the Mini DisplayPort port on the rear of the monitor and the other end to the DisplayPort port on the source device. NOTE: Depending on your DisplayPort cable connection, either the DisplayPort or Mini DisplayPort input video connection is disabled between the monitor and connected host device after the system exits from sleep state or if the input signal is lost. When the system wakes from sleep state, the monitor automatically scans to an active input video signal. If your last video input connection was to DisplayPort, the monitor automatically scans and switches to USB-C video, DisplayPort, or HDMI video input source, but not to Mini DisplayPort. If your last video input connection was to the Mini DisplayPort, the monitor automatically scans and switches to USB-C video, Mini DisplayPort, or HDMI, but not to DisplayPort. You will need to reconnect to the desired DisplayPort (DisplayPort 1) or Mini DisplayPort (DisplayPort 2) input using the OSD menu. To reconnect, press the OSD button on the monitor, select Menu > Input Control, and then the desired DisplayPort setting. ● Connect one end of an HDMI cable to the HDMI port on the back of the monitor and the other end to the source device. 3. You must connect the USB upstream cable from the source computer to the monitor to enable the USB ports on the monitor. 6 Chapter 1 Getting Started