HP Z32 User Guide - Page 17

Mounting the monitor, Removing the monitor stand

Get HP Z32 PDF manuals and user guides View all HP Z32 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

Mounting the monitor The monitor panel can be attached to a wall, swing arm, or other mounting fixture. NOTE: This apparatus is intended to be supported by UL- or CSA-Listed wall-mount bracket. CAUTION: This monitor supports the VESA industry-standard 100 mm mounting holes. To attach a thirdparty mounting solution to the monitor, four 4 mm, 0.7 pitch, and 10 mm-long screws are required. Longer screws may damage the monitor. It is important to verify that the manufacturer's mounting solution is compliant with the VESA standard and is rated to support the weight of the monitor display panel. For best performance, use the power and video cables provided with the monitor. Removing the monitor stand CAUTION: Before beginning to disassemble the monitor, be sure the monitor is turned off and all cables are disconnected. 1. Disconnect and remove all cables from the monitor. 2. Position the monitor face down on a flat surface covered by protective sheet foam or a nonabrasive cloth. 3. Press the VESA release button (1) to release the stand. 4. Swing the bottom of the stand up until the mounting plate clears the recess in the panel (2). 5. Slide the stand out of the recess (3). Setting up the monitor 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
Mounting the monitor
The monitor panel can be attached to a wall, swing arm, or other mounting
fixture.
NOTE:
This apparatus is intended to be supported by UL– or CSA–Listed wall-mount bracket.
CAUTION:
This monitor supports the VESA industry-standard 100 mm mounting holes. To attach a third-
party mounting solution to the monitor, four 4 mm, 0.7 pitch, and 10 mm–long screws are required. Longer
screws may damage the monitor. It is important to verify that the manufacturer’s mounting solution is
compliant with the VESA standard and is rated to support the weight of the monitor display panel. For best
performance, use the power and video cables provided with the monitor.
Removing the monitor stand
CAUTION:
Before beginning to disassemble the monitor, be sure the monitor is turned
off
and all cables are
disconnected.
1.
Disconnect and remove all cables from the monitor.
2.
Position the monitor face down on a
flat
surface covered by protective sheet foam or a nonabrasive
cloth.
3.
Press the VESA release button (1) to release the stand.
4.
Swing the bottom of the stand up until the mounting plate clears the recess in the panel (2).
5.
Slide the stand out of the recess (3).
Setting up the monitor
11