HP d248 Quick Setup & Getting Started - Page 22

Problem, Cause, Solution, Computer is in Stand

Get HP d248 - Microtower Desktop PC PDF manuals and user guides View all HP d248 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 22 highlights

Getting Started Problem Blank monitor screen. (continued) Cause Solution The cable connections are not correct. Check the monitor cable connection from the monitor to the computer to the appropriate connector, and to the electrical outlet. Computer is in Stand By mode. Press the power button to resume from Stand By mode. The energy saver feature has been enabled. Press any key or click the mouse button and, if set, type your password. You are using a fixed-sync Make sure that the monitor can accept monitor and it will not sync the same sweep rate as the resolution at the resolution chosen. chosen. The VGA/BNC selector Set the selector switch to agree with the switch is not properly set. cable connection. 2-10 Quick Setup & Getting Started Guide

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
2–10
Quick Setup & Getting Started Guide
Getting Started
Blank monitor screen.
(continued)
The cable connections are
not correct.
Check the monitor cable connection
from the monitor to the computer to the
appropriate connector, and to the
electrical outlet.
Computer is in Stand By
mode.
Press the power button to resume from
Stand By mode.
The energy saver feature
has been enabled.
Press any key or click the mouse button
and, if set, type your password.
You are using a fixed-sync
monitor and it will not sync
at the resolution chosen.
Make sure that the monitor can accept
the same sweep rate as the resolution
chosen.
The VGA/BNC selector
switch is not properly set.
Set the selector switch to agree with the
cable connection.
Problem
Cause
Solution