HP vc4725 Hardware Reference Guide: HP Compaq vc4725 Thin Client - Page 20

Hardware upgrades Internal battery replacement Use the following procedure to replace Internal battery 1. Complete steps 1 through 4 of the "General hardware installation sequence" on page 2-1. 2. Locate the battery and battery holder on the system board. 3. Pull back the clip that is holding the battery in place, and then remove the battery 4. Depending on the type of battery holder on the system board, complete the following instructions to replace the battery. a. To release the battery from its holder, squeeze the metal clamp that extends above one edge of the battery. When the battery pops up, lift it out 1 b. To insert the new battery, slide one edge of the replacement battery under the holder with the positive side up. Push the other edge down until the clamp snaps over the other edge of the battery 21 1 21 Removing and replacing the internal battery 5. Complete steps 6 through 10 of the "General hardware installation sequence" on page 2-2. 2-10 www.hp.com Hardware Reference Guide