HP xp8020 HP xp8000 series digital projector - (English) Reference Guide - Page 33
To connect control equipment
View all HP xp8020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Installation and Setup To connect control equipment ■ 9-pin serial cable ■ 2.5-mm (3/32-in) to 3.5-mm (1/8-in) stereo mini-phone cable ■ 3.5 × 1.3-mm DC power cable In some installations, the projector might not be visible to the remote control, such as for rear projection. Use one of these solutions to enable the remote control to work: ■ Use a remote control extension. Plug its cable into the remote connector on the projector. Install the receiver in the room with the presenter. ■ Wire the remote control to the projector. Construct a cable with a 2.5-mm (3/32-in) stereo mini-phone jack at one end and a 3.5-mm (1/8-in) stereo mini-phone jack at the other end. Plug the small connector into the remote control and the large connector into the remote connector on the projector. Reference Guide 33